Service mode SHARP

sponsored links

Posted in category: Free Download Softwere at: January 4, 2012 by nuG

MbotenGaptek Collection of all kinds of ways Sharp Service Mode

1. (older models)

Look for a switch NORMAL – SERVICE
It looked like a switch that is used on the vertical
Location of main-pcb on the back near the TUNER
To enter service mode – move to the position of SERVICE

2.

Power on
Make sure the adjustment images in NORMAL position (with remote)
Short-JA137 & JA138′s about 1 second then off again, then it will enter the service mode.
Navigation using Ch and Vol
To turn off the exit plane

Replace new memory IC (empty)

Power off
Short-right continues while JA137 and JA138
Turn on airplane
Wait about 30 seconds it automatically default data is written into memory

3.

Main-switch-off or unplug the power cord (power cord)
Press and hold down simultaneously Vol-and Ch-ups on the front panel
Turn on airplane
Navigation using Ch and Vol with remote
Exit off the main-switch (data is saved automatically)

4. (UOC slim with box)

Power on
Make sure the adjustment images in NORMAL position (with remote)
Shortkan pin-5 Mikrokontrol about 1 second and off again (or with JA484 JA483)

Press to select MODE MENU which will diadjust (Adjust Mode, Check mode, the Option mode etc.)
Navigation using Ch and Vol
Wait about 4 seconds before moving to other adjustments to previously stored data is automatically

Replace the new memory (empty)

Power off
Shortkan continue while the pin-5 Mikrokontrol to ground (or with JA484 JA483)
Turn on airplane
Wait about 30 seconds and automatically default data will be written into memory
If the default data failed – it may be caused because the ABL britnes too light or there is a problem in the ABL

5.

Press MENU on the remote
Next press the numbers 4-7-2-5
Navigation using Ch and Vol
To turn off the exit plane

Other Post Mbotengaptek :

sponsored links

Tags: Service mode SHARP | Comments (0)

Leave a Reply